The training stand has been specifically designed for demonstrating the basics of
electrical systems in motor vehicles. The components used for the apparatus are
based on the Golf 4 and are both fitted and connected to one another exactly as
they were in the original vehicle. The trainee‘s task is to lay the entire
cabling of the components in a lighting system as per the end-to-end circuit diagram and demonstrate
that all of these components are working correctly through commissioning.
Since the original DIN switching
symbols and DIN 72522 terminal designations are used, it is possible to wire up
the entire vehicle training stand exactly as shown in the circuit diagram. All components
are equipped with the specific plug-in sockets with digital diagram printout on
the base plate. This guarantees the same cabling structure at all times.
Functional
assemblies such as light switches, headlights, wipers, etc. can also be wired up
individually as an initial training exercise. Working in groups, all consumers and
switching elements can then be connected to one another in such a way that the relatively
complex system wiring diagram and interactions between the individual elements are
easier to understand.
- Working with circuit diagrams, circuit symbols, terminal designations, cables, cable connections
- Use of the possibilities of standard diagnostic equipment
- Inclusion of problem-solving strategies or alternatives in the diagnosis
- Inspection of individual components and decision on necessary repair measures
- Troubleshooting in electrical circuits
- Motor vehicle mechatronics technician with focus on passenger car technology
- Service technician
- Naming electrical and electronic components, functional units and systems
- Checking and repairing electrical and electronic circuits
- Selecting and using electrical measuring and testing equipment
- Measuring and evaluating electrical variables and signals
- Documenting work results and evaluating by comparing with calculated variables and manufacturer specifications
Ready-to-use and movable functional model, including voltage-stabilised 12 V switched mode power supply, datasheets, circuit diagrams and operating manual.
- Immediately operational and mobile functional model
- Voltage stabilized switching power supply
- All necessary connecting cables (laboratory cable with 4 mm safety sockets)
- Front side writable with foil pens
- Halogen main headlamp with dynamic headlamp levelling
- Fog lights and original rear lights, steering column switch, level sensor, wiper motor, light switch, third brake light, rear lights, license plate light, fuse box, relay
- Dimensions: L x W x H 1600 x 800 x 1950 mm
- Weight: approx. 140 kg
- Electrical connection: 240 V mains connection